Hi All, I was wondering if there are those of you who are waiting for Digtrax to resolve the problems that have been reported with the Bdl162, and maybe...
Jim, At risk of not being strongly Digitrax... I worked a small DC/DC a year or so ago exactly following a Linear Devices data sheet. Had problems persuading...
... Get them from Mouser (http://www.mouser.com) Modular plug (non-shielded) 6 position/6 conductor for flat stranded cable, part #154-UL6236 You can get jacks...
What is the problems that the BDL162 has? We are just now installing four of them and would like to know what the problem is so we don't pull out what hair we...
Hi Martin: Radio Shack has exactly what you want. They call it an RJ25 plug with 6 pins, Catalog No. 279-421. (There is not common terminology in the...
Bill, I have found that if you have your gaps an engine length away from the frog that you will experience shorts from time to time because of leaving an ...
List: My Digitrax LocoNet low voltage woes continue, after all... To recap: Chief II Radio Equipped. Three DB150 boosters. One throttle bus feeds the boosters...
Martin, Loys Toys has both the plug and wire, they are 6 conductor. If you don't know of him he advertises in Model Railroader. David Dankert ... From:...
The RJ-25s work. This is the only thing radio shack still carries that I have needed! Chris Marco [Non-text portions of this message have been removed]...
Hi Jerry: I think the key is the PS12. It would appear you are drawing too much current for the PS12 to handle. This is shown by the lower than normal ...
... To be honest, I haven't actually contacted Digitrax yet on my BDL162. I posted here first thinking that what I was experiencing was something I was doing...
I'm currently installing a PM42 and BDL162. To test my wiring, I setup a simple temporary layout which consists of two reverse loops connected by a single...
I had the same problem. My dealer handled the fix by increasing the sensitivity of the PM 42 to the polarity change If you can handle the chore fine, if not...
Locally our Ace Hardware store carries these. Bob Wintle Parsons, Ks. ... From: Martin [mailto:hiawatha100@...] Sent: Friday, August 01, 2003 12:43 AM...
I asked this question of tech support but am not sure if they really understand what I mean.I have an electrofrog turnout that solely powers a loco storage...
A new message appeared in my DT400 throttle...."MID". According to the Digitrax throttle manual, it mentions in Sect 15.0 under decoder status that the text...
Check your turnouts, I use Walthers/Shinohara out of the box and they are power routing and will play havoc with autoreversing if the reversing section butts...
... I think the greatest advantage of the 'electronic flywheel' would be to keep the locomotive moving when there is a brief short circuit. The problem now is...
... A myth perpetuated by the laptop makers. NiMH batteries are not as quick to develop memory effects as NiCads, but they DO have the same problem. Li-ion...
All, I am interested in switching moves and have been using Kadee products, but their operation leaves a lot to be desired when attempting realistic moves,...
I work for UP and like it was posted before in this non-related subject to digitrax group discussion, UP wants to ensure the quality of its logos and image and...
Jim, Just a cross selection of previous postings on the BDL162 problems. Postings 48262/265, 49059/107/111, 52105/148, 56415, 57934, 58245/261/262, 59606. I...
I appreciate the prompt responses I've received. A bit more information: * I have the sensitivity of both reversing sections set to "Fastest" * Both reversing...
