(1) the atmosphere is friendly and relaxed. We do not welcome abusive language or profanity. We are also thankfully short on flame wars, so let's keep it...
gt4@yahoogroups.com
Sep 1, 2003 8:34 am
96263
Hi Rob!! You should get it started however, the M-, M+, and MTT are for the I/C pump and the car will run rich as you like without them.. After that for a...
I also want to replace the factory AFM, any ideas on what to replace it with? It seems so restrictive. That battery definately has to go to the boot. Tim ...
Hi all Well after reading a post the other week expressing the virtues of the GT4 box and how strong it is I feel truely annoyed that nobody told my gearbox it...
Does anyone know the fitting sizes for the brake and fuel lines on a ST165? I have someone that can get me braided lines for free, to repay a favor. Is there...
Dave, Sounds like yours did the same as mine, though I'm not sure of what went wrong with either, I don't think it has anything to do with the strength of the...
Jeremiah Yeah, it is just a wear thing, but still damned annoying Interestingly, after speaking to another UK owner, he knew of a box, the 151 one, fitted to a...
David, ring Ian Ashton,he is just in the process of setting up ALLTRAC TUNING SPECIALISTS,in the northwest, I know for a fact that he has an a box from an "a...
Thanks John I may have already found a 205 box this evening, but I'll note down the number anyway, if I don't ring about his gearbox I may ring about engine...
... Hi Tim; ... How about a Used VPC ? They turn up all the time on Ebay. You need a chip for an MR2 or a GT4. If you are Lucky you get a harness too. Link...
Hi Stephen, I found this out first hand for myself just last week actually. You are very correct, it definitely WON'T fit! lol. That said, where there is a...
Robert, Richard Doig's website has the ST205 diagram's that I used for wiring up my car: http://gtfour.supras.org.nz/diagrams.htm The LEV pin is for the water...
Though extremely rare, you could also try to find an ST185RC AFM. It is much bigger then the standard 185's. It does look very similar to the MKIII Supra's, ...
hi, i was wondering is it safe to mix racing fuel with normal 92 octane? is there any differents when they are mix together? thanks brandon 91 alltrac with...
Hi All I guess it was bound to happen - after the waterpump and split radiator tank I have now gained a slipping clutch. Its OK unless I get boost, then it ...
Hi Tony Good to see you are still alive mate! too may clutch dumps for the old girl hey. Mate give me a call tomorrow on the mobile or send me an email to work...
... From: "Chris Dittrick" <chris@...> ... head? still using the tvis.. ... only to find that the turbo is still way to high and there is work needed ...
Hey Steve, ... Haha no kidding. I had originally intended to use the ST165 intercooler, so I installed the st165 manifold while the engine was out, then I...
... From: "Chris Dittrick" <chris@...> ... we are on to a winner here! ... in its orignal position, and then a reclocked...more verticle im thinking? ...
David, I used to have an 87 GTs celica, Bought cheap because it was "stuck" in 5th gear. I popped the 5th gear cover off, and found the shift interlock pins on...
I got a variable boost controller and am want to hook it up. My understanding of boost controllers is that it gets installed before the actuator, but the...
Thanks for that Scott I've already sourced a 205 box, so I think that's going in, but once I've got the other out I'm now a bit more hopeful about it's chances...
Geoff, If the engines and ecu's in question are all US spec, then there should not be any conflicts. Scott McClendon 88 ST165 91 SW20 97 A4 2.8QM 03 YZ250F ...
I didnt think so..I might have the different TB, but I have all those parts off my 93, just need a good set of internals. Found a motor+tranny for $700...
my 185 box cost £1,700 ro repair...and it had only lost 4th gear so i doubt verymuch that you will be able to get a cheap repair unless i was totally shafted...
1,700 just to replace 4th gear? My currency converter puts that @ $2,700 US... I hope that includes removal and installation? That's sounds really high though....
