Ok, I tried. But they were out of stock, so I fell back on Firstgear, I like their stuff and service. I do have a pair of gloves I like so I'll have Gerbing...
Thanks Rod, good solution. I went for the Gerbing's per ripcbx1 instructions, they were out of stock so I bought, received, and have subsequently employed...
Looks good to me... Anyways, in addition to fuel leaking out of the carbs and onto the floor, leaking needle (float) valves can cause fuel to leak into the...
Just think how clean the engine internals will be after an oil/filter change. Michael A. Alvarez 2003 Red NH 750,"My Precious" 72K and Going Strong! Forget the...
Hi to all you very wise people. I have been working on a 82 650 nighthawk. I bought this from my cousin for $250 and it has not been rode much since 2002. I...
Hi Rob, those connectors between the carbs are made of some kind of fuel resistant plastic or in some cases aluminum and have orings on them for a tight fit....
They look great to me. I was thinking of getting the CL-950 set http://www.cycleluggage.com/nelson_rigg_cl950_saddlebags.html They are about the same but have...
For those of you that were having trouble with the center stand operation... today I found out that (and in hind site, it is kind of simple, so easy to...
I went for another 100 mile ride yesterday, parked the bike and went to work. When I came out this morning, I found a few spots of oil on the ground under the...
I love the fact that you can just slide them off, that makes real sense to me. What actually holds them on? and is it on the rear of the seat or more to the...
Sure; drain plug, filter etc. If you're parking in a clean spot you should be able to tell about where the oil is coming from. Get on your back and look up...
Steve, You might want to pop off the side cover (black in color - just above oil fill) and check your clutch master cylinder. Mine leaked slightly at the...
So here's my writeup of what I did. Hope this helps you guys out if you plan to swap your handlebars. For this project you'll need: Electrical tape Dish soap ...
um, well, some folks here have removed the spring in the petcock(PC) and have to manually turn it off after a ride. Might be a tear in the valve but doubtful....
Hi Rob, auto stores have fuel-proof tubing and carb fittings for domestic and foreign cars so you may want to ask around there. $38 for a foot or so of the...
... and have to ... doubtful. Have you ... No, I have not had it open, a tear in the diaphragm sounds likey cause the bike was pretty much un touched when I...
Not for me... unless you meant both of my feet... I was actually pulling the bike over onto myself (obviously giving up before causing any damage to either of...
hello to all night hawk members i am looking to sell my 1985 night hawk,i would like to trade for some thing i can drive all my kids in at once.it has just...
... one. http://newyork.craigslist.org/lgi/mcy/592943966.html ... hawk,i would like to trade for some thing i can drive all my kids in at once.it has just...
Hey, Rick. Try the program Any Video Converter, available at download.com. It's free and will convert just about any video format to any other. Then you should...
Vacuum line goes on the nipple (can I say that here?) located farthest to the outside of the petcock assembly and facing toward the front. the other nipple...
... I have these on my Nighthawk 750. They work great. I used some old bicycle rack pads as supports to keep them from sagging. I posted about them in...
