Bob, I will defer to you on this one, but in my experience all those York-type units sound like a beer bottle rolling around in a trash can. Stephen In a...
Can anyone help me track down a used front wheel for an 06 Grand Sport? would appreciate any help ! Thanks CT FerrariList@... [Non-text portions of this...
Hey Fellow Bora Owners, Where are folks finding those thick copper crush washers for the brakes? I'm in the final throes of trying to get my Bora back together...
Brian, Unless the washers are really ruined you can re-surface and re- anneal them. Stan Bishop wrote up an excellent piece for cam alignment on the V8 many...
If you can determine the From Address, I can talk to the offender and/or remove them from the list if they're unresponsive. Or maybe I will get a response, and...
... I think I discovered the source of the auto-reply to every message. Hopefully, I corrected the problem. ;-) Let's see if this works... Regards, Doug...
Does anyone know where I can get my hands on that annoying rubber/plastic gromet that acts as a steering dampner or stabilizer on 1985 Biturbos? It's located...
It's a bushing as in a bearing. Some have replaced it with a custom fabricated bronze piece. It shouldn't be breaking once a year. It's also a Fiat part. Bob...
I may be wrong but I think the piece being referred to is a rubber bushing, not a bearing. Maybe the later cars have a bearing which is a much better idea but...
OK then. Yes it's a bushing but not made from bronze as it should have been. It's not there as a vibration isolation piece but as an actual bearing and it has...
Anyone have a guide or link for troubleshooting Biturbo turbo boost problems? My turbo needle would get up to yellow and red quite easily when I hit the gas....
Hey! Oil and boost are not connected. You've got a pressure leakage somewhere. Is it a carbed car or injected? Carbed car, and the leakage is usually located...
After disassembling and cleaning, I realized that I hadn't noted the carb jet sizes and now don't know which ones are for the primary throttle and which for...
Thanks to Spiro Mandylor, who confirmed that the correct carb jet setup for my 1986 Biturbo Spyder(main jet/emulsioner tube) is 115/55 for the primary throat...
Anyone know anything about using turbo timers with Maserati Biturbos? They keep the car running after you've turned it off and then shut it down automatically...
Because in this forum it is set to send yor reply to the poster, not to the group. you must choose "Reply to All" for the reply to go the forum in this group. ...
If you're replying on-line via the website make sure the "To:" box has Maserati@yahoogroups.com in it. Unlike all other groups on Yahoo this moderator has it...
You were right. Vaccum advance plastic bridge piece was cracked. You could actual hear and feel the power fading in and out. Unfotunately you have to buy the...
Some people shouldn't be allowed to own cars http://www.carpoint.com.au/used-car/MASERATI/COUPE/Victoria/csn6098034.aspx -- Keith Woollard Senior Consultant ...
It's RED...so it's either a Ferratzi or a Masetutti...quel problemo ? [:-?] ReV ... http://www.carpoint.com.au/used-car/MASERATI/COUPE/Victoria/csn6098034.a\ ...
I need the clutch alignement tool to re-install the clutch in my Bora. Since I didn't have to purchase a new clutch I don't have the plastic alignment tool...
