they program via serial , through a progrming box like thing wich has read and write buttons wich is very hard to try and find schematics for and to make...
Unfortunately, Kev, that's only XP's version (imitation) of DOS, which just doesn't, not when the com port's full attention is needed to talk to the radio. ...
Its an analog system. Thanks for the information, its been a great help. I am just getting my feet wet dealing with the repeaters in my system. One thing I...
Do you have a local shop that you can get assistance from? A voting system can be a daunting task with experience! And might you consider 4.9 for your ...
I am trying to program a MTX8000 so that the 3 position toggle on the top of the radio can be use to switch the rotory from being used to switch between talk...
Got a pair of Kenwood TK-353 uhf radios. Got the Kenwood KPG-26D software and a KAWA 2 in 1 programming cable. I have used this cable before on a Kenwood...
gday all ive got a C63CXB-7106BT MSF5000 here and i have tried to program the unit via bootdisk dos on a pentium 100 through the front control connector and...
hold the button on the top next to the volume knob (the C button i think) and the function button below the PTT button and turn the radio on. hold both...
If you don't have a floppy drive, I have seen mentioned making a DOS bootable CD from an image. I keep an old DOS computer around (actually 2 variations one...
... Yes I have, and it does "seem" to work, but I can't get the program to map my archive directories properly, so I can't pull up a codeplug to modify it. It...
You might want to map a directory structure that is fat32.. not ntfs... like store your codeplugs on a flash drive.... they are normally fat32... I suspect...
Hi,I am having trouble with being able to recieve a group selcal from a gme TX7000 to a simoco srp9100 and srm9000. I am using encode and decode tone set...
We have installed several of these units. All in all they are good. However, on a downside, we have had one or two loose programming settings with large...
The version of HVN9025 CPS that you need depends upon which firmware load is in the radio and, of course, what version of CPS was last used to program the...
I have a maxtrac 300 radio that the monitor light is stuck on... I have tried a new mic and have been told that this might be an option that must be changed...
Mark, Some MaxTrac mikes have only one wire in the hang-up circuit, and must be hung on a grounded clip in order to take the radio out of monitor mode. Later...
hi anybody know where i can get this software it is for thef 500 radio i think thatsthe model tried the sites no luck but i may have got it wrong regards &73...
How do I keep the clock set to the right time??? It loses time at 5 minutes per day or more HT-1250 AAH25RDF9AA5AN [Non-text portions of this message have...
HI, I've got one of those nit-picky questions. The 154 frequency you mention, is that one of the MURS frequencies? Or does your group already have one that...
This problem was addressed by Service and Repair Note #SRN-1498A, issued in October 2005. A bug in some early firmware caused the real-time clock to ...
did doug's suggestion fix your problem? dosbox was developed for gamers who wahted to play older games on newer pc's. so it makes sense that it doesn't like...
