Hi, new member here. I just acquired the Kenwood TK-2100 murs handheld radios. I need the schematic or wire diagram for the programming cable, to be able to...
Which radio is it for ? 73, Dick, W1KSZ ... From: radio-programming@yahoogroups.com [mailto:radio-programming@yahoogroups.com]On Behalf Of Michael Stone Sent:...
As I could use this also, it is for the Kenwood TK-7189/8189E radios. Of all the KW software I have this is not one. Ron Handke 307 S. Arthur Ave. Manito, IL...
hi there, I am chasing a Simoco SRM9025 control head. Must be in very good to excellent condition. Email me joc@... if you have one for sale. THANKS Joc...
Hi Radio friends First of all the very best wishes for 2007 for all of you. I'm looking for a diagramm to make a opc-592 cloning cable. This is the programm...
Hi to all (and a happy new year to you all to) recently purchased a quantity of Motorola Refurb Kits for the GP300. For reference the part number is REX4674A....
Hmmm I tried to be a bit descreet about what I was needing. One person caught on but was unable to help me. The jist of it is my CPS is to old now and I need a...
Hi, everybody on the group, have a very good and happy new year.. I am looking for howto controlling and programming radio with unix/linux, i have opc478u, and...
Hi to all. Wonder if anyone can help. I have a GP300 (8channel UHF, non keypad) Where even though the RSS shows the channels are programmed and has been cloned...
... Yes, I'd be suspecting a board or switch fault. (Had one 16-channel unit that did one eight-channel block twice). The switch has binary address lines, so...
Hi there. Thanks for that the obvious question is, is there a means to possibly correct the fault. My particular speciality is voltage in the hundereds of...
Thanks for all the help I received, the repeater is now programmed and working . Juan, XE2SI Asunto: [radio-prog@yhgrps] Pins for programming cable EF Johnson...
Then I would suggest a visit to this site, while I am sure older members know of this, I will again post the site. Travel at your own risk, but I have used...
Nile, The reason that the radio family nameplates are not included in the cosmetic refurb kits is because there are nefarious individuals who seek to sell to ...
I am now the proud owner of a couple trade-in "Smart Com 32" handheld VHF radios. I have found the owner's manual and that the radio can be field programmed by...
... Possibly. First, check with a multimeter that rotation of the switch is causing each pole (except the common one!) to go high and low when it should. If...
