The list has been quiet again, so here's something for people to talk about. Last September I did an event at the Shenandoah Circuit at Summit Point. On day...
This is a very well known problem on Mustangs. My 95 T-2 Cobra had this problem it's entire career. It is the vent in the gas cap. As near as I can figure it...
Do you have turndowns? If they aren't pointed seriously down, iow, if they have too much rearward vector in them, you could be heating your tank. If you were...
I had the same issue, and after being black-flagged over an over again, I finally put in a cell with a flap valve. Do something to prevent sloshing up the...
Darius, Nice pic of your car. I thought you were including an example photo. George. _____ From: rrax-mustang@yahoogroups.com...
George Kokolakis
rgbcons@...
Mar 8, 2007 4:08 pm
35643
This is very strange. I had a fuel leak in the RR at Shenandoah last year, too. Mine was during the NASA American Iron race. Anyway, I've fought past a couple...
I think he is. Look below and left of the fuel fill door. Al H _____ From: rrax-mustang@yahoogroups.com [mailto:rrax-mustang@yahoogroups.com] On Behalf Of...
Oops, sorry. Now I see it. I too have this problem. I was black flaged ages ago on this. They got used to it as everyone figured it was a fact of life with my...
George Kokolakis
rgbcons@...
Mar 8, 2007 4:43 pm
35647
Is the EVAP system hooked up properly and functioning? I would replace the gas cap if you havent already. The gas cap seems to be a common failure for the EVAP...
I had that similar leak when I turned left. The leak turned out to be the donut seal that is around the filler tube going into the tank. the seal was worn...
Mike, I had replaced the gas cap but I still had the same leaking problems. It always seemed to me that the gas cap could have had a better seal with the ...
George Kokolakis
rgbcons@...
Mar 9, 2007 3:24 am
35650
Jim, Is there a part number for this seal? How do you fix it? George. _____ From: rrax-mustang@yahoogroups.com [mailto:rrax-mustang@yahoogroups.com] On Behalf...
Any parts-counter monkey can give you the part (number). They're plentiful R/R equals pulling the filler tube from the tank or the tank from the tube ......
Kent (and others who said the same thing), It may be that you're right, that it's the cap, but I don't think that's it. The drain line that comes down the fuel...
Mike, I think the EVAP/vent system may be the problem. I know the vent canister is removed from the engine compartment, and the engine doesn't have any of the...
I fixed the links. They are perfect for what you might need, nice post Darious! The part number is F4ZZ-9072-DA and runs $35. I used a little vasoline to...
This part number is for 94- Mustangs ... used ... Ezzentually ... where ... have ... http://www.mustangandfords.com/projectbuild/mufp_0701_factory_five_rac ......
I bought my 86 directly from the CHP in 88 with 85k mi on it. Years later, the pump went and I dropped the tank and replaced the pump. I later learned about...
waitaminnit... Is this a sloshing or a pressurizing issue? I use a fuel safe cell, so the venting issue is taken care of, but it's that 22gallon mustang cell...
Tom - Good stuff with the access panel, I was actually thinking of doing that myself while I have the tank out this time. If I do it, I think I'm going to make...
I probably should do that. I didn't remove the canister myself, though, so I don't have any of the components. Next time I get to a junkyard I'll have to see...
the 86 has both pieces integrated as a single assy ... __ Tom Stangler, Va Beach, VA Track Car: 300HP '86 5.0 Mustang, "5.0 RACER" Street Car: 345HP '99...
Mustangs are Mustangs, but track days are track days! OT I know but I had to share, I took my motorcycle to Buttonwillow on Saturday, and oh man was it fun!...
Tom, I was going through the articles on your web site and I was curious about the T-Bird lower control arms on the 86 Mustang. Are the bushings on the T-bird...
