Hej Per. Det stykke du spørger om er sideplade. i bund på front Volvo orginal nr.679268-3. Venlig Hilsen Volvo19712000 ... Fra: Per Lykkehus Truelsen...
I have just acquired my 4th 164! It is a '69 with a build No of 006014, quite early. I have been looking into the 164 Parts Catalogue at the table, in the...
In the beginning there was nothing else than the B30A so they didn't bother to call it anything else than "B30". When the E and F engines came, with the 1972...
Hi Just wondering if anyone has had any problems with replacing the universals on the 164 drive shaft. I have just had all three universal joints replaced,...
My 1971 164 auto has developed an unpredictable failure to start. Sometimes it will not even crank as if the battery is flat (it's near new). It seems if I...
No Walter it is not the plastic cover. Per Truelsen (164 fanatic/lover) Denmark only one 164 from 70 ... From: Walter Bellamy To: volvo100list@yahoogroups.com ...
You might want to check and be sure that the shaft balance weights are still intact where they used to be, also check the "Carrier Bearing" (and it's rubber ...
Sounds like the neutral safety switch/sensor. Try to bypass it and see what happens, then see if you can get a replacement if this is the problem. -John In a...
Dark, mysterious forces can work on driveshafts. Beleiev me, I know. Re-check whether the two halves are in phase. From personal experience I know that they...
I had the exact same problem on mine, except the problem was worse, i couldn't start the engine when it was in the 'Park position', though the 164 will still...
for the last few months i've been gearing up to convert my 70 164 to 74 B30E. today i pulled out the gearbox and prepared the engine for removal. i'll hoist it...
The '69 164 I collected on the weekend had spent about six years parked under some trees. How can I get all the debris out of the air vent? Where and by what ...
6 Bolt is better. The only reason to use the 8 bolt B20 or B30 motor is that B21 pistons fit straight on the conrods. The 8 bolt conrods are the same as what...
Hi Walter, Just played this game with my '74 164E... The water normally finds its way down and comes out of a little gap between sheet metal underneath the...
cool. no flywheel issues in that case. how can camshafts be identified on these motors? which is the one to have for high power (though with decent torque low...
Thanks Curt. I hope it's not the mountings as I've only done 77,000 miles (it was owned till about 5 years ago by an elderly gentleman). I'll have that checked...
6 as well. The 8 bolt rods are weaker & heavier + the pistons are probably a little heavier too. There is no benefical reason to carry heavy rods & pistons so...
Hans, about the middle of last year I seem to remember you were looking for some kind of bracket for a right hand drive car with air cond. I am about to scrap...
Dear all A thread was running on the relative strenght of the 6 vs 8 bolt cranks. After a little inquiry it seems that most people running and building race...
You could put B21 pistons in an 8-bolt B30, but it isn't really worth the effort, it's gives less than 5% increase above a normal .040" overbore. You could...
